User Guide

FOOT SUPPORT ADJUSTMENT

Refer to figure 14.

Leg length discrepancy: Loosen the allen screw (1), the outer screw on

the mounting bracket, for the shoe holder which needs to be lowered.

Lower the shoe holder, by lowering the shoe holder support bar (2), to

accommodate the lower leg. Tighten the screw.

Abduction: Loosen the screws (3), located on the footrest mounting

brackets underneath the shoe holders. Adjust the width between the

shoe holders by sliding them along the footrest bars (4). Note:

Excessive abduction may cause increased weight

bearing on the medial

borders of the feet. Tighten the screws.

Plantarflexion/Dorsiflexion: Loosen the screws (3). Rotate the shoe

holders about the footrest bar. Tighten the screws.

4. Rotation: Loosen both flat head screws (5) on the top of the shoe

holder. Pivot the shoe holder about the rear flat head screw. Tighten the

screws. Repeat for both shoe holders.

Depth: Loosen the allen screw (6). Slide the foot support along the

support bar. Tighten the screw. Repeat for both shoe holders.

Figure 14