User Guide

12
TRAY ADJUSTMENT
Refer to figure 12.
1. Height: Loosen the two allen screws (1) and slide the tray along the
upper column to the desired height. Tighten the screws.
2. Depth: Loosen the two knobs (2), located underneath the tray. Slide the
tray along the tray bar to the desired depth. Tighten the knobs.
3. Angle: Release both hand knobs (3). Rotate the tray about the tray
mounting bar to the desired angle. Make sure the teeth on the angle
locks mesh. Tighten the hand knobs.
1
2
3
Figure 12