User Guide
14
Adjustable Knee Supports:
a)
Angle: Loosen the allen screws (A) and tilt to the
appropriate angle to support the knees. Retighten.
b)
Width: Loosen screws (A) and slide to the correct
width to assist in alignment of the lower extremity.
Retighten.
c)
Height: Small height adjustments can be made by
loosening the single lever screw (B) and moving the
knee pad on the vertical post.
d)
Depth: Loosen the single lever screw (C), place the
Knee Block at the appropriate depth, and retighten.
Foot Support Adjustments:
a)
Footplate. Height: Release the push pin (D), and adjust
the height.
b)
5-
Way & 6
-
Way Foot Supports:
1)
Height: Release the push pin (D), and adjust the
height.
2)
Leg length discrepancy: Lower foot support to
accommodate the lower leg by releasing the push
pin (D) and placing it at the appropriate height.
Then unscrew the side with the shorter leg and
adjust accordingly.
3)
Abduction: Loosen the screws under the shoe
holders (E) and adjust the width between the shoe
holders. Note: Excessive abduction may cause
increased weight
-
bearing on the medial borders of
the feet.
4)
Plantarflexion/Dorsiflexion: Loosen the same
screws as for abduction (E) and adjust.
5)
Rotation: Loosen the nuts under the shoe holders
and pivot.
6)
Inversion/Eversion: Loosen the allen screws (F) and
adjust the angle. Retighten.