User Guide

ADJUSTMENTS :

Note: The adjustments for height are made with the hip

support as the stationary mid

point. All adjustments are

made up or down from this point. Removal of the tray is

necessary to make the adjustments.

NEVER MAKE

THESE ADJUSTMENTS WITH THE CHILD IN THE

STANDER!

Trunk Support:

Pushing in on the push pin (A), pull the

pin and move the upper column up to the desired

distance from the hip support. Replace the pin. Remove

pin (B) and adjust the height of the sternum support to fit

to mid sternum.

This is not a chin rest!

Replace the pin.

Pitch:

Remove the push pin (C) while holding on to the

upper portion of the stander. Slowly move the stander to

the desired pitch and replace the pin.

Hip and Trunk Support Widths:

(You may need to

loosen the straps to increase the width.) Loosen the black

inside knobs (D) and slide the bars to the appropriate

width. It is very important to make sure that the outsides

of the bars are an equal distance from the mid

line of the

column. If they are not, the child may not be weight

bearing evenly. Tighten the knobs and re

velcro the

inside strap. This will be adjusted later as part of the

"fine tuning" while the child is in the stander. Complete

this adjustment for both the upper and lower supports.

Tray Support:

Adjust the angle of the tray by removing

the push pin, while supporting the front of the tray, and

lifting or lowering the tray to the desired angle, then

replacing the pin.