User Guide

7. Finally add all the hardware. The slings (fig 10a) will

simply slide into the sling holding clamps or the intact

sling units can be slid on to the main column and secured

with push pins. The supine neckrest (b) drops down into

the column and is secured with a push pin. The knee

block unit (c) slides on to the main column and are

secured with a push pin. The shoe holders (d) can slide

up on to the bottom of the column and be secured with a

push pin. Lastly, the tray (e) drops into its mounting

tubes.

8. Check to make sure the stander is working properly.

Squeeze the tilt trigger (fig 10f) with your left hand, and

use your right hand to pull back or push forward the

column.