User Guide

PEER LEVEL STANDER OPTIONS:

Supine Neckrest and/or Shoulder Pads:

Assembly:

a) Slide the mounting support tube (fig. 13a) into the top

of the column, and secure it with the push pin.

b) Measure the height to the top of the child s shoulders

and then to the mid ear.

c) Adjust the height of the shoulder pads to the height of

the top of the shoulders, and the middle of the

neckrest to the mid

ear height, using the foot supports

as the baseline. Adjustments are made using the allen

screws. Tighten screw when done.

Fitting:

a) Release the shoulder pad pivots by pulling the rings

(fig. 13b) back to release and swing open (pointing

away from the column.)

b) Place the child into the stander (see page 18).

c) Adjust the depth of the neckrest by releasing the two

allen screws (c) that attach it to the vertical mounting

bar.

d) Swing the shoulder pads back into place.

e) Adjust the width of a shoulder pad by loosing the

allen screw (d) under the bracket and placing it in the

correct position. Retighten the screw.

f) Adjust the depth of the shoulder pads:

Loosen the front retainer ring (e) to allow

adjustment.

Loosen the rear index clamp (f) and move the

shoulder pads in place to provide the appropriate

amount of anterior support.

Tighten the index clamp (f), making sure that it is

aligned so that the shoulder pad will lock in two