User Guide
14
Adjustable Knee Supports
1)
Angle: Loosen the allen screws (fig 12A) and tilt to
the appropriate angle to support the knees. Retighten.
2)
Width: Loosen screws (A) and slide to the correct
width to assist in alignment of the lower extremity.
Retighten.
3)
Height: Small height adjustments can be made by
loosening screws (B) and moving the knee pad on the
vertical post.
4)
DO NOT ADJUST THE PLACEMENT OF THE
COLUMN BRACKET (F) ON THE STANDER!
Foot Support Adjustments:
1)
Footplate Height: Release the push pin (fig 12C), and
adjust the height.
2)
Five-
Way Foot Supports:
a)
Height: Release the push pin (C), and adjust the
height.
b)
Leg length discrepancy: Lower foot support to
accommodate the lower leg by releasing the push
pin (C) and placing it at the appropriate height. Then
unscrew the side with the shorter leg and adjust
accordingly.
c)
Abduction: Loosen the screws (D) and adjust the
width between the shoe holders. Note: Excessive
abduction may cause increased weight
-
bearing on
the medial borders of the feet.
d)
Plantarflexion/Dorsiflexion: Loosen the screws (D)
and adjust.
e)
Rotation: Loosen the nuts under the shoe holders
and pivot.
f)
Inversion/Eversion: Loosen the allen screws (E) and
adjust the angle. Retighten.
3)
AFTER ADJUSTING FOOT SUPPORTS,