User Guide
10
TROUBLE SHOOTING:
Careful alignment of the Peer Level Stander during
assembly is critical to the correct functioning of the
mechanical tilt mechanism. If the stander doesn t tilt
correctly after assembly check the following list of
common problems.
The frame is not square: The side frames need to be
parallel to each other and the frame braces need to be
perpendicular to the side frames.
The knee block bar is not parallel to the frame braces.
The column is twisted. The push pin holes need to be in
line with the column pivot.
FITTING INSTRUCTIONS:
The following measurements are required prior to fitting
the Peer Level Stander:
1.
Heel to iliac crest:
This is the measurement to the top of
the hip support. ___
2.
Groin to mid
-scapula:
This is the measurement to the
top of the trunk support. ___
3.
Floor to mid
-
knee:
This is the measurement to the
middle of the knee support. ___
4.
Hip width:
This is the measurement of the width of the
hip support. ___
5.
Trunk width:
This is the measurement of the width of
the trunk support. ___
6.
Leg length discrepancy:
The amount of distance that
the individual foot support must be lowered on the
longer side. ___