User Guide

PEER LEVEL STANDER OPTIONS:

Prone Neckrest and/or Shoulder Pads:

Assembly:

Mark the position of the foot and knee supports and

then remove them from the main column. To remove

the foot supports, pull out the push pin and slide the

support off the column. To remove the knee supports,

do the same, as well as loosen the two allen screws

securing it in place.

Slide the mounting support tube (fig. 14A) into place,

with the tube sticking out backwards between where

the knee blocks go.

Reattach the knee and foot supports to their original

positions.

Attach the remaining segments to the mounting tube

(fig 15).

Measure the height to the top of the child s shoulders

and then to the mid ear.

Adjust the height of the shoulder pads to the height of

the top of the shoulders, and the middle of the neckrest

to the mid

ear height, using the foot supports as the

baseline.

Fitting:

Remove the mounting by pulling out the push pin (fig.

14C).

Place the child into the stander (follow the

instructions).

Release the shoulder pad pivots by pulling the ring

back to release and swing open (pointing away from

the column.)

With the child in the stander, slide the mounting

column (fig. 14B) onto the horizontal tube (fig. 14A)