User Guide

9
Refer to figure 9.
1. Remove the allen screw
from the bottom part of
the upper column.
2. Slide the upper column
down into the lower
column.
3. Line up the holes in the
upper and lower columns
(1).
4. Insert the allen screw (1)
and tighten.
Step F: Adding the Mobility Kit
Refer to figure 10 (steps 1 - 3) and figure
11 (steps 4 - 10).
1. Attach the brake clamp (1) to
the frame support with four
3/4 allen screws (2) so a
circular opening is formed. Do
not tighten the screws
completely (it may already be
attached).
2. Slide the brake tube (3) through
the hole created by the frame
support and brake clamp.
Tighten the allen screws.
3. Repeat steps 1 & 2 for both the left
and right side frames.
4. Wheel mounting plate orientation:
Attach the wheel plate (4) to the
outside face of the frame support. If
these are already attached, skip to
step 9.
5. Attach the upper edge of the wheel
plate with two 7/8 allen screws.
Insert a washer through each of the
screws between the screw head and
Figure 11
2
1
3
4
Figure 10
Figure 9
1