User Guide

22
Neckrest Support System (Prone):
Refer to figure 29 & 30.
Attaching the neckrest support system to the OMNI
TM
:
1. Remove the upper column: Unscrew the safety screw from the column
(see Step E in the assembly instructions for details). Loosen the
adjustment lever on the main column. Slide the upper column up and
out of the main column.
2. Add the neckrest support system: Loosen the two allen screws (1),
located on the side of the neckrest bar clamp. Slide the neckrest bar
clamps onto the main column. Tighten the two screws.
3. Replace the upper column: Slide the upper column back into the main
column. Tighten the adjustment lever on the main column.
1
Figure 30
Figure 29