User Guide

OPTIONAL CONFIGURATIONS

Always remove the child from the stander before alterations are made.

Prone Stander w/o Mobility Kit:

Refer to figure 19, figure 20 (step 2),

and figure 21 (steps 3,4).

1. Remove the drive wheels: Depress

the button in the center of the quick

release while pulling the wheel off

the frame. Remove both drive

wheels. Refer to figure 8 of the

Assembly Instruction.

2. Remove the drive wheel plates

(optional): Loosen and remove the

four screws (1) so the wheel plate

(2) can be removed. Repeat for both

sides. Remember to keep track of

the washers and screws for

reassembling. There will be twelve

washers and four allen screws from each side.

Remove the drive wheel brakes: Loosen the four allen screws (3).

Slide the brake support tube off the frame support. Tighten the screws.

Repeat for both sides.

Remove the brake clamps (optional): Loosen and remove the four allen

screws (3). Repeat for both sides.

Locking the stander in place: The OMNI

comes equipped with step

activated locking rear castors. To lock/unlock, step down on the

castor s foot peddle.

Figure 21

Figure 20

Figure 19