User Guide

16
TRAY ADJUSTMENT
Refer to figure 16.
1. Height: Loosen the two allen screws (1) and slide the tray along the
upper column to the desired height. Tighten the screws.
2. Depth: Loosen the two knobs (2), located underneath the tray. Slide the
tray along the tray bar to the desired depth. Tighten the knobs.
3. Angle: Release both hand knobs (3). Rotate the tray about the tray
mounting bar to the desired angle. Make sure the teeth on the angle
locks mesh. Lock the cams.
Figure 16
1
2
3