User Guide

21
To adjust the pad front/back, disengage the sliding lock
behind the seat, and allow the pad to swing down (Figure
26). Loosen the now exposed hex head bolt until the tube it
is attached to is free to slide (tool not included). Move the
bar to the desired position, and tighten the allen screw.
Swing the pad back up into place.
IMPORTANT: Make sure the rear seat pad arm can lock
back into place after each rear seat pad adjustment!
The basic setup of the Gait Master is now complete.
For instruction on how to get in and out of the Gait
Master see the Getting In & Out section. For fine
tuning, see the Fine Tuning section.
Figure 25
Figure 26