User Guide

For unicycle style type seats:

The seat can be slid along the seat support frame. Start

by having the nose of the seat approximately 1inch (2.5

cm) from the center vertical column. To adjust the seat

position, loosen the T

screw, and slide the seat (Figure 24,

a). Then, tighten the screw.

The pitch of the seat can be adjusted. Loosen the four

nuts located under the seat (tool not provided) and tilt the

seat. Tighten the nuts (Figure 24,b).

Tapered style seats (not shown) cannot be adjusted on the

seat support bar.

The rear seat pad can be adjusted up/down and front/

back. Exact placement of the pad is user preference.

To adjust the pad up/down, loosen the two allen screws

on the block attached to the back of the pad. Slide the pad

up/down, and tighten the screws (Figure 25).

Figure 24