User Guide

19
Adjust the depth of
the thoracic support so it
is equal to measurement #4
as shown in Figure 22.
Loosen/tighten the two
allen screws located on
the underside of the foam
padding.
The width and depth of the thoracic support can be
adjusted further when the user is in the unit. Do not place
the user in the unit at this time!
Additionally, the thoracic support can be tilted in any
angle to maximize proper support. A good starting angel is
about 20 degrees up from the floor. To modify the angle,
loosen the top two allen screws on the center thoracic
block. Adjust the thoracic angle, and tighten the screws
firmly (Figure 23).
Figure 22
#4
Screws
Figure 23