User Guide

18
Adjust the height of the thoracic support so about 7
inches (18 cm) separates the sternum pad and front
thoracic pad. Loosen the four allen screws located on the
center block to slide the thoracic support up/down as
shown in Figure 20. The location of the thoracic support
can be adjusted further when the user is in the unit. Do not
place the user in the unit at this time!
Adjust the width of the thoracic support so it is equal to
measurement #3 as shown in Figure 21. Loosen the two
allen screws located on the underside of the front thoracic
pads. Make sure the distance from the center vertical
column to the left and right sides of the thoracic pads are
equal for symmetric support.
Figure 20
Figure 19
~7in
#3
Figure 21