User Guide

11
When changing between the 10 and 18 - degree angles for
the front leg, make sure both knobs on the front leg are in
the unlocked position before rotating the leg. It is only
required to lock the knob that relates to the desired leg
angle position.
If the silver and colored frames are not
together: Confirm that the pull knobs
near the top of the square tubes are in
the unlocked position (retaining pin is
in the shallow slot) as shown in Figure
7. If they are in the locked position, the
upper frame will not slide into the lower frame.
Actuate the gas springs* to make insertion of the upper
frame into the lower frame easier (This may already be
done for you before the unit was packaged).
Pull the ring toward the front of the unit
while rotating the gas spring release lever
toward the right side of the Gait Master .
Refer to Figure 8. The ring may by
released once the handle is vertical.
Continue to rotate the handle until both gas
springs stop rising out of the square tubes.
*Caution, the gas springs
will extend upward out of
the opening of the square
tubes (Figure 9), and can do
so with much force and
speed. Keep clear of the
opening of the square tubes
while actuating the gas spring release handle.
Figure 7
Figure 9
Pull
Figure 8