User Guide

Now that the frame is assembled the seat
and back inserts can now be put on, this
makes the frame more rigid.
Find the location hooks on the base of the
seat these need to be hooked around the
hexagonal pegs found on each seat cane .
The front end is located first then the back,
and its locked into place by pulling the metal
cable down , the seat should then locate into
the location pegs.
The back then is connected in a similar
manner with the top pegs being located first
(Dia. C) then the metal cable is pulled
downwards and the bottom hooks lock in the
pegs (Dia. D).
Picture C - Peg and Hook on Back cane
Picture D - Metal cable and bottome hook
The detachable foot plate is connected by
hooking the metal castings over the toothed
casting (make sure the clamping mechanism
is fully released to allow the castings to fit
freely. Once you have the desired angle set,
push in on the spring loaded pin and push the
lever down. (make sure the teeth fit snuggly
toghether)
To swing away the footrests pull up the locking
mechanism and rotate the footrest in the
required direction.
ACROBAT INSTRUCTION MANUAL
C
E