User's Manual

ENTR Wi-Fi Tiny Bridge integration Guide de
April, 24, 2017
An ASSA ABLOY Group Brand
Page
16
3.3.5 WPS Configuration
You can connect to the Tiny Bridge’s Wi-Fi network with Wi-Fi Protected Setup (WPS), to use
WPS procedure do the following:
 Make sure that the Tiny Bridge has power (its green Power LED is lit steady).
 Press the WPS button on the Tiny Bridge for 3 seconds (WPS button is located on the bottom
right of the Tiny Bridge) until the Wi-Fi white color led start blinking.
 Within two minutes, on your router, press its WPS button or follow its instructions for WPS
connections, now wait for the WPS setup to end till the Wi-Fi white color led will lit steady.
 Now wait that the Wi-Fi amber led will lit steady (white color led will turn off) to indicate the
Tiny Bridge join the network successfully ,If the WPS configuration fails the white led will
turn off and a solid red led will lit to indicate that the Tiny Bridge fails to join the network.
 If the WPS procedure fails or the wireless router does not support WPS procedure go to
paragraph 3.3.3.