User's Manual

ENTR Wi-Fi Bridge integration Guide
April, 24, 2017
An ASSA ABLOY Group Brand
Page
22
Appendix A
WPS Configuration
You can connect to the Bridge’s Wi-Fi network with Wi-Fi Protected Setup (WPS), to use WPS
procedure do the following:
 Make sure that the Bridge has power (its green Power LED is lit steady).
 Press the WPS button on the Bridge for 3 seconds (WPS button is located on the bottom
right of the Bridge) until the Wi-Fi white color led start blinking.
 Within two minutes, on your router, press its WPS button or follow its instructions for WPS
connections, now wait for the WPS setup to end till the Wi-Fi white color led will lit steady.
 Now wait that the Wi-Fi amber led will lit steady (white color led will turn off) to indicate the
bridge join the network successfully ,If the WPS configuration fails the white led will turn off
and a solid red led will lit to indicate that the Bridge fails to join the network.
 If the WPS procedure fails or the wireless router does not support WPS procedure go to
paragraph 3.3.3.