Specifications

07
(Figure A)
(Figure B1)
(Figure B2)
( Figure B1.B2 )
( Figure C )
(Figure C1)
(Figure C)
1. Insert 3.5” IDE hard drive into the slot. Turn the
front side upward. (Set the HDD to MASTER if
needed).
2. Connect the larger 40-pin IDE connector of
TransImp-SATA/IDE to USB 2.0 Adapter to
the hard drive.
3. Connect a 4-pin power connector from power
supply to hard drive.
4. Turn on the device power.
5. Connect the USB cable to the USB port on the PC.
Once connected properly, the HDD should be
automatically detected and be ready for use.
3.5” IDE Hard Drive Installation:
( Figure A )
IDE 3.5”
Hard Drive
IDE 2.5”
Hard Drive
SATA/IDE to USB 2.0 Adapter
3.5”/5.5”
OFF
ON
(B2) (B1)
(C1)
IDE 3.5” Hard Drive
IDE 3.5”
Hard Drive