User guide

877-2-MUELLER

D-4

ROOF INSULATION (CONTINUED)

Double sided tape or contact adhesives can be used to hold insulation in place while the roof

sheets are being installed. Trim excess insulation to the edge of the eave trim and cut ﬁberglass

approximately 4 inches from end leaving only facing. Fold facing over end of blanket insulation to

seal the end.

Cut Fiberglass from Vapor Barrier

and Fold Vapor Barrier Over

Blanket

Insulation

Double-sided

Tape

#12 Self-Drilling

Wall Fastener

Allow room to

install sealant tape

and closure strip

Eave Trim

(Trim shape

may vary)

Eave Strut

Outside Closure

(Optional)

NOTE: Do not install more insulation on the roof than can be covered by roof

panels before the work period ends. Do not allow the insulation to become wet.