User guide

www.muellerinc.com
C-13
INSTALLATION OF WIND BRACING (CONTINUED)
Assemble the next brace cable the same way and connect to the next column to form an “X” with
the other cable.
To square the building, measure the length of the diagonals and tighten or loosen the turnbuckle/
eye-bolt until the lengths are the same. Double-check by using a square at the corners.
Brace each sidewall frame the same way so that you have an x-brace on each side. Note that the
diagonal lengths may vary between the two walls, but should be the same on each x-brace.
Tighten the column anchor nuts after ensuring that the building is square.
The diagonal bracing is cable. It should always be installed as shown on the erection drawing and
should be tensioned so that the building will not sway or rock when the wind blows. Care should
be taken; however, not to over tighten and bend the structural members. The workman should
watch the structural members carefully as he tightens the bracing.
Column
Eyebolt
Turnbuckle
Cable