24x24 (D.I.Y.) with Optional Center Girts and Floor Kit Instructions Mueller D.I.Y. buildings are not engineered structures and do not meet any specific building code criteria. 877-2- MUELLER • www.muellerinc.
Mueller Mueller Inc Inc ‐ 6 x 9 DIY Back Yard Kit Instructions; Instructions; For For additional additional information, information, see see the the D.I.Y D.I.Y Installation Installation Video Video PG 2 Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video st parTs lIsT ng improvements, please refer to the parts list on the itemized invoice delivered with your building. All ciled on the inside ofRefer the channel, purlin, and rafters.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Types of screws Lap TEK Screw For attaching sheet metal to sheet metal TEK Screw For attaching sheet metal to purlin ⅞" 1 ¼" 36" 10" Lap TEK Screw 12" TEK Screw 12" TEK Screw NOTE: Make sure to use TEK screws to attach sheets to purlins, lap TEK screws to attach sheets to sheets.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Base layout (bc-1 and BP-1) BC-1 (Base Channel) BP-1 (Base Purlin) STEP 1 Insert BP-1 into BC-1 BP-1 (Base Purlin) NOTE: Leading and trailing edge of channels are overbent for a tight fit. Spread apart as needed to nest the purlin into the channel.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Make sure the assembly is square NOTE: Mueller recommends the building be placed on leveling blocks (not included) to support the base channel and purlins. Mueller also recommends the building be anchored to the ground or foundation. The method of anchor is at the owner’s discretion. Make sure the assembly is square. Assembly is square when the corner to corner measurements are equal.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Floor Kit (Optional) NOTE: Mueller recommends the building be placed on leveling blocks (not included) to support the base channel and purlins. Mueller also recommends the building be anchored to the ground or foundation. The method of anchor is at the owner’s discretion.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Erecting Columns (C-1) Attach column to MKB-1 (Galvanized MKB-2) clip using 1/2"x1" Fin Head Bolts HINT: Add clips to top of columns before standing up.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Rafters (R-1) Bolts should remain loose until EC-1 is installed Place one bolt as shown.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Eave Channel (EC-1) Tighten bolts after EC-1 is installed.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Make sure the assembly is square and level Make sure the assembly is square. Assembly is square when the corner to corner measurements are equal. Use temporary bracing (not included) to hold assembly square if required.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Door TRim and Mid-Girts (Wide OR Narrow RUD: Optional - MG-1, MG-2 and MG-3) 20 NOTE: Bolt to inside of column leg Mid-Girts for Narrow RUD RUD 5'-9.5" x 6'-5" -3 MG -1 G M Mid-Girts for Wide RUD RUD 7'-9.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Eave Trim Window (optional) Lap TEK Screw Start sheet 3/4" past steel line. Sheet 1" above bottom of base channel Use inside/outside closures behind drip trim DripTrim NOTE: Sheets below window will need to be field cut for window assembly. Insert window and flap flush to sheet. Add drip edge window trim when installing eave trim.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Sheeting Screw placement WALL SHEETS 36" 10" Lap TEK Screw 12" TEK Screw TEK Screw ROOF SHEETS TEK Screw 36" 10" Lap TEK Screw 12" 12" TEK Screw Place sealer tape between roof sheets only. 12" TEK Screw TEK Screw NOTE: Make sure to use TEK screws to attach sheets to purlins, lap TEK screws to attach sheets to sheets.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Sheeting NOTE: Make sure the frame is plumb and level, and tighten all bolts prior to sheeting. Repeat for each wall. TOP VIEW Door Door Jamb Panel J-Trim NOTE: For side with door, start sheets flush with J-trim on both sides of the door.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Sheeting (Note some sheets are Longer) NOTE: Sheets are stepped. Longer sheets are in the middle of the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Sheeting Sidewall with RUD door To install the RUD, see the RUD video and instructions. Outside closures NOTE: If using optional walk door, set jamb trim inside measurement at 5'10⅛". Inside closures 1" Endwall IMPORTANT: 1" above the bottom of the base channel Top View Sidewall Inside closure goes on the bottom and outside closure goes on top.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Sheeting Sidewall Endwall Top View Sidewall 1" Inside closure goes on the bottom and outside closure goes on top.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Top View Sidewall Sheeting eNDwall without door Endwall Inside closure goes on the bottom and outside closure goes on top.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Back Side Wall Roof to wall sheet alignment Align major ribs from wall to major rib on roof NOTE: Make sure panels remain square during installation.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video 30 36" 10" 12" 12" Sheeting the roof Align roof sheets with wall sheets Place sealer tape between roof sheets to avoid leaks Lap TEK Screw TEK Screw TEK Screw TEK Screw Inside Closure Eave Trim SIDE View 2.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Roofing TRim details CAUTION: Use scaffold boards (not included) for support while installing roof sheets and trim.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y. Installation Video Skylight Ridge Roll Installation CAUTION: Use scaffold boards (not included) for support while installing roof sheets and trim HINT: S crew corner of ridge roll and middle first to maintain pitch. Install remainder of screws. Foam Block (under Ridge Roll) Ridge Roll Outside Closure Lap TEK Screw Roof Panel Foam Block closes the gap in between the closures.
Mueller, Inc. 24x24 DIY Back Yard Kit Instructions; For additional information, see the D.I.Y.
