ArKion Systems Under Glass Module (UGM) Manual Document Rev 0.
UGM Manual Document Information Title: UGM Manual Version: 0.1 Created: 12/8/2008 Last Modified On: 12/8/2008 Author: Technical Lead: Contributors: Revision History Version Date Author Comments 0.1 12/03/08 TC Initial draft, submitted for review 0.2 Reviewers Reviewed By Page ii Title Date Reviewed ArKion Systems – Confidential Rev 0.
UGM Manual Table of Contents 1. 2. 3. 4. 4.1 4.2 Introduction .............................................................................................. 1 Supported Products ................................................................................... 1 Product Block Diagram .............................................................................. 1 Requirements for FCC ................................................................................ 2 PRODUCT IDENTIFICATION ................
UGM Manual 1. Introduction The ArKion UGM (Under Glass Module) is an ISM band 902 to 928 Mhz frequency hopping transceiver module. There are two radio performance options for this module, a high power module with RF output power between 26dbm and 30dbm and a low power module with RF output power of between 10dbm and 16dbm. The modules are intended to be installed in an off the shelf electric meter with an interface providing power and a serial data connection to the UGM module.
UGM Manual Super caps Antenna +5V RF TX 3.3V 3.3V RF RX RF RX CTRL DATA RF LNA RF211 IF1 10.7Mhz MMCX Connector 10.245 Mhz TCXO T/R Switch PWR REG 9-15V Unreg IF2 455Khz Meter interface & Buffers CTRL Serial data Atmega 128 uP TEMP BATT SPI FLASH Temp Sense RTC RTC CLK 32.768 Khz Osc 7.3728 Mhz Osc UGMLG Block Diagram +3.3V To Electric Meter Figure 1. UGM Low Block Diagram RF PA RF LNA CTRL DATA MMCX Connector T/R Switch PWR REG Meter interface & Buffers Figure 2.
UGM Manual LCD panel only to ensure 20 cm will be maintained if the user places the device in their lap for use) and 2) The transmitter module may not be co-located with any other transmitter or antenna. 3) The end user should NOT be provided any instructions on how to remove or install the device. As long as the 2 conditions above are met, further transmitter testing will not be required.
UGM Manual 4.2 FCC Identification This product contains Module FCC ID: SM6-UGM-H This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Figure 4. FCC Label Page 4 ArKion Systems – Confidential Rev 0.
