User Manual

ManualsBrandsMueller Systems ManualsElectronicsDCOM4 Transmitter

Table Of Contents

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598

Certification Exhibit

FCC ID: SM6-MINODE-WATER4

IC: 9235A-MINODE4

FCC Rule Part: 15.247

IC Radio Standards Specification: RSS-210

ACS Project Number: 15-0006

Manufacturer: Mueller Systems, LLC

Model: MiNODE-WATER4

Summary of content (7 pages)

PAGE 1
Certification Exhibit FCC ID: SM6-MINODE-WATER4 IC: 9235A-MINODE4 FCC Rule Part: 15.247 IC Radio Standards Specification: RSS-210 ACS Project Number: 15-0006 Manufacturer: Mueller Systems, LLC Model: MiNODE-WATER4 5015 B.U.
PAGE 2
MINODE–WATER4 Installation Manual
PAGE 3
MINODE–WATER4 Installation Manual Table of Contents 1. 2. 3. 3.1 3.2 3.3 3.4 4. 5. 5.1 5.2 5.3 Introduction .................................................................................................. 4 Construction .................................................................................................. 4 Installation .................................................................................................... 5 PIT SET INSTALLATION ..................................................
PAGE 4
MINODE–WATER4 Installation Manual FCC Information: Changes or modifications not expressly approved by the Mueller Systems could void the user's authority to operate the equipment. IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
PAGE 5
MINODE–WATER4 Installation Manual 1. Introduction The Mueller Systems MINODE-WATER4 is intended for indoor and outdoor use as an unattended Automatic Metering Infrastructure (AMI) and control device. The MINODEWATER4 is fully self-contained and battery powered device with no user accessible controls.
PAGE 6
MINODE–WATER4 Installation Manual 3. Installation MINODE-WATER4 modules support two mounting options, either mounting to a ½” PVC pipe for pit set installations or affixed to the side of a building. Pit set installations require no drilled holes through the lid and are mounted beneath the polymer meter box lid for security and ease of installation on PVC pipe. Surface mounts are easily accomplished with the integral mounting brackets and two screws (not included). 3.
PAGE 7
MINODE–WATER4 Installation Manual MINODE-WATER4 Translator Register Badger ADE Register Sensus ECR and ICE Registers Neptune PRORead, AUTORead, E-Coder Registers Red Red Red Red Black Green/White Green/White Green Green Red Black Black Black Black Green Table 1. MI.NODE - WATER Meter Interconnect 3.4 Verification Following installation the Mi.Tech Hand-held should be used to verify proper installation and operation. Please refer to the Mi.Tech manual. 4.