User's Manual

ManualsBrandsMueller Systems ManualsElectronicsAutomatic Water Metering

This Mueller Systems proprietary and confidential document shall not be reproduced or

retransmitted in any way without expressed written consent from Mueller Systems

Mi.Node – Water3

Installation Manual

880-0052-001

Document Rev 0.2

Summary of content (8 pages)

PAGE 1
Mi.Node – Water3 Installation Manual 880-0052-001 Document Rev 0.
PAGE 2
MI.NODE – WATER3 Installation Manual Document Information Title: Version: MI.NODE – WATER3 (Mi.Node Water3) Installation Manual 0.2 Created: 05/28/2009 Last Modified On: 05/29/2009 Author: Tom Cullinan Technical Lead: Contributors: Revision History Version Date Author Comments 0.1 05/28/09 TC  Initial draft, submitted for review 0.2 05/29/09 TC  Incorporated comments from review, changed product name to Mi.Node Water  Reviewers Reviewed By Rev 0.
PAGE 3
MI.NODE – WATER3 Installation Manual Table of Contents 1. 2. 3. 3.1 3.2 3.3 3.4 4. 5. 5.1 5.2 Introduction .............................................................................................. 1 Construction .............................................................................................. 1 Installation ................................................................................................ 2 PIT SET INSTALLATION ...............................................................
PAGE 4
MI.NODE – WATER3 Installation Manual FCC Information: Changes or modifications not expressly approved by the Mueller Systems could void the user's authority to operate the equipment. IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
PAGE 5
MI.NODE – WATER3 Installation Manual 1. Introduction The Mueller Systems MI.NODE – WATER3 is intended for indoor & outdoor use as an unattended automatic metering Infrastructure (AMI) & control device. The MI.NODE – WATER3 is fully self-contained and battery powered device with no user accessible controls. The MI.NODE – WATER3 for Residential Metering (“MI.
PAGE 6
MI.NODE – WATER3 Installation Manual  The electronic design utilizes the latest RF microchip technology which increases reliability when compared to older RF designs 3. Installation MI.NODE – WATER3 modules support two mounting options, either mounting to a ½” PVC pipe for pit set installations or affixed to the side of a building. Pit set installations require no drilled holes through the lid and are mounted beneath the polymer meter box lid for security and ease of installation on PVC pipe.
PAGE 7
MI.NODE – WATER3 Installation Manual 3. Orientation of the device vertically is required to maximize RF performance. 3.3 Wiring Tools Required: 3M-2Y connectors, splitting tube, and a 3M Crimping Tool MI.NODE – WATER3 Translator Register Badger ADE Register Sensus ECR and ICE Registers Neptune PRORead, AUTORead, E-Coder Registers Red Red Red Red Black Green/White Green/White Green Green Red Black Black Black Black Green Table 1. MI.NODE - WATER Meter Interconnect 3.
PAGE 8
MI.NODE – WATER3 Installation Manual 5.2 FCC Identification The text specified below is engraved into the bottom of the MI.NODE – WATER3 enclosure and indicates the FCC ID number of the product. Figure 2. MI.NODE-WATER3 FCC ID text Rev 0.