User's Manual

ManualsBrandsMueller Systems ManualsElectronicsTransmitter Module

This Mueller Systems proprietary and confidential document shall not be reproduced or

retransmitted in any way without expressed written consent from Mueller Systems

Mi.Node – CI

Installation Manual

880-0042-001

Document Rev 1.0

Summary of content (6 pages)

PAGE 1
Mi.Node – CI Installation Manual 880-0042-001 Document Rev 1.
PAGE 2
MI.NODE – C&I Installation Manual Document Information Title: Version: MI.NODE - CI (Mi.Node CI) Installation Manual 1.0 Created: 9/22/2009 Last Modified On: 09/22/2009 Author: Tom Cullinan Technical Lead: Contributors: Dave Splitz Revision History Version Date Author Comments 1.0 9/22/2009 TC  Initial draft, submitted for review   Reviewers Reviewed By Rev 1.
PAGE 3
MI.NODE – C&I Installation Manual Table of Contents Introduction .............................................................................................. 1 1. 2. Product Labeling ........................................................................................ 1 2.1 PRODUCT IDENTIFICATION ............................................................................... 1 2.2 FCC IDENTIFICATION .....................................................................................
PAGE 4
MI.NODE – C&I Installation Manual FCC Information: Changes or modifications not expressly approved by the Mueller Systems could void the user's authority to operate the equipment. IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
PAGE 5
MI.NODE – C&I Installation Manual 1. Introduction The Mueller Systems MiNODE-CI is intended for indoor & outdoor use as an unattended automatic metering Infrastructure (AMI) & control device. The SMART METER-CI product consists of a Mueller Systems AMI MiNODE-CI module fully integrated into a Landis+Gyr C&I (Commercial & Industrial) solid state electric meter. The Smart Meter-CI is fully self-contained with no user accessible controls. The MiNODE-CI interrogates the ANSI C.
PAGE 6
MI.NODE – C&I Installation Manual the Date of Manufacture, the Hardware Version and the MI.NODE–CI /Serial Number (Node ID) that is used to uniquely address the device and Assembled in Mexico. Figure 1. Product Identification Label 2.2 FCC Identification This label is affixed to the side of the SmartMeter CI enclosure and indicates the FCC ID number of the product. This product contains Module FCC ID: SM6-MINODE-CI This device complies with Part 15 of the FCC Rules.