Mueller Cellular Node User Installation Manual
Mueller Cellular Node Installation Manual Contents 1. Introduction ................................................................................................................................ 4 2. Construction ................................................................................................................................ 4 3. Installation .................................................................................................................................. 5 3.
Mueller Cellular Node Installation Manual FCC Information: Changes or modifications not expressly approved by the Mueller Systems could void the user's authority to operate the equipment. IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
Mueller Cellular Node Installation Manual 1. Introduction The Mueller Systems Mueller Cellular Node is intended for indoor and outdoor use as an unattended Automatic Metering Infrastructure (AMI) and control device. The Mueller Cellular Node is fully self-contained and battery powered device with no user accessible controls.
Mueller Cellular Node Installation Manual • A LTE PCB antenna is located in the upper housing to provide RF communication. • A single D cell long life Lithium battery is located in the lower housing which provides power for register interrogation and data transmission for a calculated battery life of up to 10 years. • There are no customer serviceable parts inside the Mueller Cellular Node housing. Batteries are not replaceable.
Mueller Cellular Node Installation Manual 3.2 Exterior Wall Mounting Tools required: 1 – 1 1/2 inch galvanized, or stainless wood or sheet metal screws (2 per), Phillips screwdriver 1. The open-ended wire from the device permits routing through interior walls for external wall mounting when required or direct mounting to exposed floor joists above grade level. 2. Mueller Cellular Node can be directly mounted to almost any flat surface by using the holes shown and common screws in most instances. 3.
Mueller Cellular Node Installation Manual Operational mode -- device operates per customer settings and is starting with the default profile. 4. Maintenance There are no user serviceable items within a Mueller Cellular Node. The battery is sealed within the module and is not replaceable. No cleaning is required. 5. Product Labeling 5.1 Product and FCC/IC Identification This label is affixed to the face of the Mueller Cellular Node unit.
