Owner's Manual

MTX.COM
5
Step 3 - Using a 1" hole saw, drill a hole in the top of the dash to pass the wiring harness through.
Our recommended location is indicated in the picture. Note: The 12-volt power port can be removed
and used to pass the harness through the dash if you do not desire to drill a separate hole. This will
require the removal of the center dash console panel to remove the power port.
Step 4 - Prepare the AWMC3 radio unit by removing the two (2) threaded studs from the back of the
radio.
Step 5 - Locate the compression plate (shown) in the kit. Install it loosely as shown into the kit by
inserting two (2) short screws included.