Owner's Manual

MTX.COM
7
Step 8 - While pressing the pressure plate forward against the radio chassis, tighten the two (2)
screws left loose in Step 5.
Step 9 - Prepare the pigtail harness supplied with the AWMC3 radio for installation by connecting
additional wire to reach power / ground locations, speaker wire if needed and amplier turn on wire.
Note: If the radio installation is part of a full plug and play kit, use the pigtail supplied with the kit and
not the radio. Start the installation by passing the pigtail harness down through the 1" hole previously
drilled.
Step 10 - At this time, any RCA signal wires should be fed up through the hole for connection to the
radio unit. Once wires are in place, make the appropriate connections to the radio.