Owner's Manual

MTX.COM
9
Step 10 - Using side cutters or a razor knife, remove the four (4) mounting tabs on the bottom side
of the panel around the speaker opening to provide proper clearance for the pod installation. Note:
These DO NOT need to be perfectly ush with the back of the panel.
Step 11 - Turn the panel over and locate the three (3) dimples around the molded speaker grill. Two (2)
on top and one (1) on bottom of the grill area.
Step 12 - Using a
3
⁄16" drill bit, drill though the panel at each dimple location.