Owner's Manual

MTX.COM

Step 17 - Tighten the machine screws securing the pod to the panel.

Step 18 - Repeat this process on the other panel.

Step 19 - With the panels back at the vehicle, route the pod speaker wire to its connection point.

Note: If installing as part of a kit, the upper pod plug will connect to the pigtail located as part of the

lower pod harness. If not installing as part of a kit, the plug will need to be removed and additional

speaker wire added.

Step 20 - It is recommended to test the system prior to full reassembly. Reinstall the dash panels

in reverse order as removed, remembering to reconnect the computer module and any switches

disconnected during disassembly.

Step 21 - Reassemble and go ride.