Owner's Manual

MTX.COM
10
Step 13 - On the speaker pods, locate the single molded dimple at the bottom of the pod face.
Step 14 - Using a
1
⁄8" drill bit, pre-drill the hole approximately
1
⁄8" deep to allow the mounting screw to
be started by hand.
Step 15 - Align the appropriate speaker pod on the back of the panel with the drilled holes and begin
securing using two (2) machine screws through the front of the panel and into the threaded holes
located on the pod bracket.
Step 16 - Once started, install the coarse thread screw through the single bottom hole into the pod
and tighten.