User Manual

MTX.COM
7
WIRING AND CONNECTIONS
Note: Turn off all power to your subwoofer and other equipment before making any connections.
Installationusingspeakerlevelinputs
A)Foramplierswithonesetofspeakeroutputsusingthepassthroughinthesubwoofer.
If a preamplier output connection is not available on your amplier or receiver, your subwoofer can
be connected using your equipment’s speaker outputs. These connections are made using commonly
available 18 or 16 gauge speaker hook-up wire. Observe correct polarity by connecting red (+) to red (+)
and black (-) to black (-) for both left and right channels. Connect your amplier’s speaker output terminals
to the subwoofer’s speaker level input terminals. Additionally, the signal can internally pass through the
subwoofer to the secondary speakers using the speaker outputs on the subwoofer. See gure below.
Caution:
To reduce the risk
of fire, replace with
only the same type
and rating fuse.
Fuse Type
T3AL / 250V
AC Voltage Selector
230V
115 V
On
Off
~115V - 230V 60Hz / 50Hz
150 Watts
In Out
L
High Level
Low Input
Auto
On Off
R
L
R
In Out
Phase
Power
Volume
Min Max 60Hz 180Hz
Crossover
0° 180°
Powered Subwoofer
WARNING: To reduce the risk of fire
or electrical shock, do not expose this
appliance to rain or moisture.
ATTENTION / CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Amplier Outputs
Speaker
Speaker