6/,+37!'%.
%!$ !,, $)2%#4)/.3 #!2%&5,,9 "%&/2% "%')..).' -/5.4).' ,/#!4)/. 4HE ENCLOSURE MOUNTS IN REAR HATCH OF 6OLKSWAGEN "EETLE ON PASSENGERS SIDE 4//,3 2%15)2%$ &/2 ).34!,,!4)/. 0OWERED 3CREWDRIVER 7IRE #UTTERS MM 7RENCH 4 4ORX 0HILLIPS 4ERMINAL #RIMPERS ).34!,,!4)/.
2EMOVE BOTH REAR SEAT SIDE PANELS 3TART PULLING AT WINDOW AND WORK YOUR WAY DOWN TOWARDS THE FLOOR PULL TOWARDS CENTER OF VEHICLE 3LIDE THE SEAT BELT THROUGH THE SLOT AND REMOVE PANEL 2EMOVE COVER UNDERNEATH DASH ON DRIVERS SIDE OF VEHICLE 5NSCREW THREE 4 TORX SCREWS AND SLIDE COVER OUT OF CLIPS 2EMOVE HOOD LEVER PULL LEVER BACK AS TO OPEN HOOD /N BACK SIDE OF LEVER REMOVE PLASTIC CLIP AND SLIDE LEVER OFF OF SHAFT 0LASTIC &OOT 0AD (OOD ,EVER +ICK 0ANEL 2EMOVE DRIVERS SIDE KICK PANEL
$RILL A HOLE THROUGH THE FIRE WALL ,OCATE A SPOT LOW ON THE FIRE WALL 9OU SHOULD ALWAYS LOOK TO FIND A CLEAR PATH $RILL A HOLE FROM INSIDE OF THE VEHICLE INTO ENGINE COMPARTMENT AND INSERT GROMMET 'ROMMET "ATTERY .
!LTHOUGH -48 HAS MADE EVERY EFFORT TO ASSURE PROPER WIRING COLORS -48 IS NOT RESPONSIBLE FOR ANY CHANGES MADE BY THE VEHICLE MANUFAC TURER WHICH SOMETIME OCCUR )F WIRING COLORS DO NOT MATCH THEN PHYSICAL VERIFICATION IS REQUIRED #/..%#4)/. 4/ %.#,/352% #ONNECT SPEAKER WIRE 2#!gS TO THE INPUTS OF PRE AMP .
3ETTING 'AIN 4URN GAIN KNOB ON 4HUNDERFORM PRE AMP TO MINIMUM COUNTER CLOCK WISE 0LAY A FAVORITE TAPE OR COMPACT DISC THAT CONTAINS CONSISTENT MUSIC AND BASS 4URN THE SOURCE UNIT TO MAXIMUM LISTENING LEVEL 9OU SHOULD KNOW THAT SOME SOURCE UNITS WILL PRODUCE DISTORTION OR hCLIPv BEFORE THE UNIT REACHES MAXIMUM VOLUME 2EDUCE VOLUME TO THE LOUDEST LISTENING LEVEL BEFORE DISTORTION 4URN THE GAIN KNOB ON THE 4HUNDERFORM PRE AMP CLOCKWISE UNTIL THE SPEAKER STARTS TO DISTORT AND REDUCE GAIN TO LOUDEST LISTENI
2EMOVE ENCLOSURE AND SCREW RUBBER PADS IN THE LOCATION WHERE ENCLOSURE NOTCHES WERE THE RUBBER PADS HOLD THE ENCLOSURE IN PLACE 0UT ENCLOSURE BACK IN PLACE RECONNECT WIRES LOCK SEAT IN POSITION AND ENJOY &OR TECHNICAL ASSISTANCE CALL #!,, -48 4HESE INSTRUCTIONS ARE GUIDELINES ONLY AND IN NO WAY ARE INTENDED TO REPLACE A PROFESSIONAL INSTALLATION !S ALWAYS BEFORE SCREWING OR DRILLING CHECK TO MAKE SURE YOU WILL NOT DAMAGE ANY WIRES OR HOSES OR CAUSE DAMAGE TO THE VEHICLE 7ARNING "ATTERI
7ARRANTY 3TATEMENT 4HUNDER&ORM ,OADED %NCLOSURES PURCHASED IN THE 5NITED 3TATES FROM AN AUTHORIZED -48 DEALER ARE GUARANTEED AGAINST DEFECTS IN MATERIAL AND WORKMANSHIP FOR A PERIOD OF TWO YEARS FROM THE DATE PURCHASED BY THE END USER AND LIMITED TO THE ORIGINAL RETAIL PURCHASER OF THE PRODUCT !MPLIFIED 4HUNDER&ORM %NCLOSURES PURCHASED IN THE 5NITED 3TATES FROM AN AUTHORIZED -48 DEALER ARE GUARANTEED AGAINST DEFECTS IN MATERIAL AND WORKMANSHIP FOR A PERIOD OF ONE YEAR FROM THE DATE PURCHASED BY THE END USE
Mitek Mobile Limited Warranty Our Guarantee Mitek Mobile products (including MTX, Streetwires, Coustic and Magnum) purchased in the USA after 1/1/2013 from an authorized Mitek retailer are guaranteed to be free from material defects in products and workmanship for five (5) years to the original end user purchaser, subject to the terms and conditions below.
No Other Warranties THE LIMITED WARRANTIES DESCRIBED ABOVE ARE EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED. MITEK DISCLAIMS AND EXCLUDES ALL OTHER EXPRESS WARRANTIES, AND DISCLAIMS AND EXCLUDES ALL WARRANTIES IMPLIED BY LAW, INCLUDING WITHOUT LIMITATION THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
