Owner's Manual

I
Step
16-
Now
that
the
enclosure
is
securely
tightened in
place,
the
power
and signal
wires
need
to
be
connected
to
the battery and signal
source.
•
The
Red
wire
should be connected
directly
to
the battery's positive
terminal
and fused
with
a
20A
fuse.
•
The
Black
wire
should
be
directly
connected
to
the battery's negative
terminal.
•If
your
vehicle
is equipped
with
the
Polaris®
buss bar kit, the
Red
and
Black
wires can be
connected
to
the buss bar under the hood on the
firewall.
The
Red
wire
will
still
need
to
be
fused.
•
The
Blue
wire
can
be
connected to the
ACC
I
Key Turn
On
located
on
the buss bar of any
vehicle.
Step
17-
Connect the
RCA
inputs to the
signal
source
of
your choice
Step
18-
Turn the unit on and
check
to make sure everything works. Set the gain using the gain pot
that
is attached to the orange
I
grey
wires
. Set the gain
to
the bass
level
desired.
Step
19-
The
included
EBC
can
be
connected and mounted
to
a desired
location
to
allow
easy trim
adjustment of the bass
level after
the
gain has been set.
Step
20-
Replace all the parts and
screws
that
have been removed
to
return the
RZR
back
to
its
completely assembled
state.
10
MTX
.
COM