Operator`s manual

701333-004 5-15
Configuring the 1330 in ASCII Mode
To specify your choice, follow the configuration procedure that begins on Page 5-1.
Enter your choice (0 or 1) and press Save.
403 – Alarm on Error
Use Configuration Option 403 to specify whether a beep sounds when an error occurs. If
you specify NO (by entering 0), the alarm does not sound.
noitpO eciohC gninaeM
304
)oN(0sruccororrenanehwdnuostonseodmralaehT
)seY(1tonhguoht(sruccororrenanehwsdnuosmralaehT
)tluafed()mralaehtdnuossrorrella
To specify your choice, follow the configuration procedure that begins on Page 5-1.
Enter your choice (0 or 1) and press Save.
404 – Print Head Style
When you change the print head, you must inform the 1330 which print head style is
currently installed by using this configuration option.
Caution
Failure to enter the correct print head style under Option 413 can result in poor print head
performance and damage to the print head.
Before specifying the print head style, turn the printer off. Refer to the label on the print
head to determine which style of print head is installed. If you are installing a new print
head, see “Replacing the Print Head” in Chapter 7 for instructions.
To select a print head style, follow the configuration procedure that begins on Page 5-1.
Enter your choice (1 or 2) as defined in the following table:
noitpO eciohC gninaeM
404
1)tluafed(daehtnirp1elytS
2daehtnirp2elytS
If the correct print head style number is displayed, press Save. If the number does not
correspond to the print head style, enter the correct number (1 or 2) and press Save.
405 – Print Head Column Spacing
Configuration Option 405 enables you to correct for spacing variations between the banks
of print wires on the print head. If the dots in the letters on the printout do not appear to