Operator`s manual

701333-004 5-13
Configuring the 1330 in ASCII Mode
308 – BC Space CHR
Configuration Option 308 enables and disables the processing of the ANSI Space character
as an actual bar code character. With this Option disabled, the ANSI Standard rules
apply to the processing of Space characters. With this Option enabled, the ANSI Space
character is processed as an actual bar code character and the ANSI comma character
serves as a bar code separator as well as a space character to move the print position one
space to the right.
noitpO eciohC gninaeM
803
0rabasaretcarahcecapSehtfognitnirpehtelbasiD
)tluafed()dradnatSISNA(retcarahcedoc
1rabasaretcarahcecapSehtfognitnirpehtelbanE
)dradnatSIICSA4224(retcarahcedoc
To specify your choice, follow the configuration procedure that begins on Page 5-1.
Press the Right Arrow or Left Arrow key to make your choice. Then press the Save key
to make your choice the active selection.
Note: This option does not affect 4224 ASCII bar codes.
309 – Bar Code Control
Use Configuration Option 309 to configure the ANSI bar code printout.
noitpO eciohC gninaeM
903
1ehtnitnofedocrabdradnatsehtsesU–dradnatS
dedecerpeblliwedocrabISNAdradnatS.retnirp
.ecapsetihwfohcninafo4/1ybdewollofdna
)tluafed(
2rabtnerrucehtnehW.devreseR–tnoFdesserpmoC
ottluafed,elbaliavatonsitnofdesserpmocedoc
.ezisdradnats
3ebotpudevomsielbadaernamuhehT–IRHresolC
fohcninafo4/1ehT.flestiedocrabehtotresolc
edocrabehtswollofdnasedecerptahtecapsetihw
.devomerera
To specify the bar code control default, follow the configuration procedure that begins
on Page 5-1. Enter your choice (1, 2, or 3) and press Save.