Operator`s manual

5-12 701333-004
Configuring the 1330 in ASCII Mode
305 – Automatic Perforation Skip
Use Configuration Option 305 to specify whether or not the printer automatically skips
a form perforation. If this option is enabled, the printer skips three lines at the end of
each page.
noitpO eciohC gninaeM
503
0)tluafed(piksnoitarofrepcitamotuaelbasiD
1piksnoitarofrepcitamotuaelbanE
To make your choice, follow the configuration procedure that begins on Page 5-1. Enter
1 to enable automatic perforation skip or 2 to disable automatic perforation skip, and
press Save.
306 – Ignore Sign
Configuration Option 306 ignores ANSI CRT control codes and the printer Deselect
command when received in the datastream. This option only affects TI-810 emulation.
noitpO eciohC gninaeM
603
0lortnoc018sasedoclortnocTRCISNAssecorP
)tluafed(dnammoctceleseDtpeccadnasedoc
1ehterongidnasedoclortnocTRCISNAerongI
dnammoctceleseD
To specify your choice, follow the configuration procedure that begins on Page 5-1.
Press the Right Arrow or Left Arrow key to make your choice. Then press the Save key
to make your choice the active selection.
Note: The Up Arrow and Down Arrow keys cannot be used to get to this option.
307 – Bit Graphics
Configuration Option 307 enables and disables Proprinter Bit Graphics escape commands
and the Shift-In (SI) command. This option only affects the Proprinter emulation mode.
noitpO eciohC gninaeM
703
0dnammocISehtdnascihparGtiBretnirporPelbasiD
1dnammocISehtdnascihparGtiBretnirporPelbanE
)tluafed(
To specify your choice, follow the configuration procedure that begins on Page 5-1.
Press the Right Arrow or Left Arrow key to make your choice. Then press the Save key
to make your choice the active selection.