Operator`s manual

4-24 701333-004
Configuring the 1330 in 3270 Mode
Note that you will only be able to access the option that corresponds to the device you
have in the printer; that is, if you have a DID device, the menu will only allow you to
access the DID Load Adjust option.
Loads can be initiated in Stop or Ready mode with a DID device, but only in Ready
mode with a DOD device.
420 – Stop Mode Timeout (TO)
Configuration Option 420 enables you to select what the 1330 will do when it has been
in Stop mode for more than 10 minutes. You can specify whether the printer will continue
in Stop mode, or whether it will go to Start mode.
noitpO eciohC gninaeM
024
1
ti,setunim01nahteromrofedompotSnitfelsi0331ehtfI
edomtratSotnruterlliw
smrofehthtiwedompotSnitfelsi0331ehtfi,edomDODnI
yllacitamotualliw0331eht,setunim01nahteromrofdetceje
edomtratSotnruterdnasmrofehttcarter
2
na,setunim01nahteromrofedompotSnitfelsi0331ehtfI
niniamerlliw0331ehtdna,deyalpsideblliwegassemrorre
)tluafed(edompotS
To specify your choice, follow the configuration procedure that begins on Page 4-1.
Enter your choice (1 or 2) and press Save.
422 – Start Mode After Eject
Configuration Option 422 enables you to set the 1330 so that it automatically goes into
ready mode when you press the Load key twice. This will also cause the paper to retract.
noitpO eciohC gninaeM
224
seY
resuehtnehwedomydaerotniseogyllacitamotua0331ehT
)tluafed(eciwtyekdaoLehtsesserp
oNtcejeretfaedompotSnisniamer0331ehT
To specify your choice, follow the configuration procedure that begins on Page 4-1.
Enter your choice (Yes or No) and press Save.