Operator`s manual

701333-004 4-23
Configuring the 1330 in 3270 Mode
noitpO eciohC gninaeM
514
)oN(0delbasidsirosnestuorepapehT
)seY(1)tluafed(delbanesirosnestuorepapehT
To specify your choice, follow the configuration procedure that begins on Page 4-1.
Enter your choice (0 or 1) and press Save.
416 – Paper Skew Sensor Enable
Use Configuration Option 416 to enable or disable the paper skew sensor. If you specify
NO (by entering 0), the paper skew sensor will be disabled.
noitpO eciohC gninaeM
614
)oN(0delbasidsirosnesweksrepapehT
)seY(1)tluafed(delbanesirosnesweksrepapehT
To specify your choice, follow the configuration procedure that begins on Page 4-1.
Enter your choice (0 or 1) and press Save.
418 – DOD Load Adjust
Use Configuration Option 418 to set the distance between the top of the form and the
bottom of the characters in the first print line. Values range from 20 to 255, in .007-inch
increments.
For example, if you have a box you want to print in as the first print line, measure the
distance from the physical top of the form to the line you want to print on. Convert the
distance to .007 inches and enter the distance as the value for the Load Adjust parameter.
Note that you will only be able to access the option that corresponds to the device you
have in the printer; that is, if you have a DOD device, the menu will only allow you to
access the DOD Load Adjust option.
Loads can be initiated in Stop or Ready mode with a DID device, but only in Ready
mode with a DOD device.
419 – DID Load Adjust
Use Configuration Option 419 to set the distance between the top of the form and the
bottom of the characters in the first print line. Values range from 20 to 255, in .007-inch
increments.
For example, if you have a box you want to print in as the first print line, measure the
distance from the physical top of the form to the line you want to print on. Convert the
distance to .007 inches and enter the distance as the value for the Load Adjust parameter.