Operator`s manual

B-34 701333-004
Programming Notes
Font Control and Download Commands
The following commands are download commands. Refer to the IBM Proprinter III and
Proprinter III XL Guide to Operations for information on how to design and print
download characters.
noitcnuF edoC lamiceD xeH
)teSGClanretnI(ytilauQtfarDtceleS0ICSE0037720094B1
)teSGCdaolnwoD(ytilauQtfarDtceleS4ICSE4037724094B1
)tnoFtsaF()teSGClanretnI(IPC21tceleS1ICSE1037721094B1
)teSGCdaolnwoD(IPC21tceleS5ICSE5037725094B1
QLNtceleS2ICSE2037722094B1
)teSGCQLNlanretnI(QLNtceleSGCSE177274B1
)teSGCQLNlanretnI(QLNteseRHCSE277284B1
)teSGCdaolnwoD(QLNtceleS6ICSE6037724094B1
)teSGClanretnI(IIQLNtceleS3ICSE3037723094B1
)teSGClanretnI()cilatI(IIQLNtceleS>B0<ICSE113772B094B1
)teSGCdaolnwoD(IIQLNtceleS7ICSE7037727094B1
)teSGCdaolnwoD()etanretlA(IIQLNtceleS>F0<ICSE513772F094B1
sretcarahCdaolnwoDenifeD2tc1tc=CSE
0an02
11p...2p1p
2tc1tc1672
0an02
11p...2p1p
2tc1tcD3B1
0an41
11p...2p1p
Font Control and Download Commands
Note: (ct1) and (ct2) specify the number (k) of character codes to be defined, where
256ct2 + ct1 = 13k + 2.
(a) refers to the attribute byte. Setting Bit 7 = 0 specifies the top 8 print wires.
Setting Bit 7 = 1 specifies the bottom 8 print wires. Bits 4 through 6 specify the
starting column(s), where (0<s<7). Bits 0 through 3 specify the ending column
(e), where s + 4<e<11.
(a), (0), and (p1 p2...) must be repeated for each character code being redefined.