Operator`s manual

B-30 701333-004
Programming Notes
Horizontal Tabbing Commands
Absolute and relative horizontal tab stops are controlled with the commands listed below.
noitcnuF edoC lamiceD xeH
baTlatnoziroHetucexETH9090
spotSbaTlatnoziroHteS0kn...1nDCSE00kn...1n867200kn...1n44B1
sbaTlatnoziroHraelC0DCSE0086720044B1
etatSnO-rewoPotsbaTlatnoziroHteseRRCSE287225B1
Horizontal Tabbing Commands
Note: (n) specifies the print position. Up to 28 horizontal tab positions can be set, with
the first print position as 1.
Vertical Movement Commands
Paper motion is controlled with the commands listed below.
noitcnuF edoC lamiceD xeH
deeFmroFFF21DO
deeFeniLFL01A0
)612/552ot0(hcnI612/nfodeeFeniLnJCSEn4772nA4B1
*hcnI8/1otgnicapSeniLteS0CSE847203B1
*)612/552ot612/1(hcnI612/notgnicapSeniLteSn3CSEn1572n33B1
*hcnI27/7otgnicapSeniLteS1CSE947213B1
*)27/58ot0(hcnI27/notgnicapSeniLteSnACSEn5672n14B1
*nACSEotgnicapSeniLtxeTtratS2CSE057223B1
deeFeniLotuAteS15CSE1035721053B1
teseR05CSE0035720053B1
gnicapSeniLesreveRnjCSEn60172nA6B1
Vertical Movement Commands
*Reset with another line spacing.