Operator`s manual

5-26 701333-004
Configuring the 1330 in ASCII Mode
600 Attachment
The following options define the printer’s attachment selections.
601 – Interface
Configuration Option 601 enables you to manually select the 3270 or ASCII interface
from the dual interface card when installed in the 1330 printer.
noitpO eciohC gninaeM
106
0ecafretni0723ehtfoesuehterugifnoC
1ecafretniIICSAehtfoesuehterugifnoC
2fitluafeD(secafretniIICSAdna0723ehthtoberahS
)dellatsnisidraobecafretnilaud
To specify your choice, follow the configuration procedure that begins on Page 5-1.
Enter your choice (0 or 1) and press Save. The 1330 will automatically reinitialize to the
interface chosen.
Note: The keypad options will change based on the selection you make.
Note: Option 601 will not appear if the dual interface card is not installed.
602 – Idle Timeout
Use Configuration Option 602 to specify the number of seconds that must elapse with no
activity in the active mode before the printer enters idle mode.
noitpO eciohC gninaeM
206
0.edomevitcanatixetonlliwretnirP
n–1atadonsierehtnehwedomevitcanatixelliwretnirP
.sdnocesnretfassecorpot
If data is present in the nonactive mode when the printer goes idle, the printer changes
mode and prints the data. Otherwise the printer will remain idle until it detects data in
either interface. The range of seconds you may choose from is 0 to 99. In 3270 mode, the
default is 30 seconds; in ASCII mode, the default is 5 seconds.