Owner manual

INSTALLATION:

Step 1 – First determine where you would like to

place the speaker and at what angle the speaker

will be mounted. Place enclosure on bar with

desired angle and make a mark in the middle of

the wire hole on the bar. This mark will be where

the speaker wire will come thru the bar into the

enclosure.

Step 2 – Drill a

⁄8" hole for the speaker wire on the

mark that you made. Deburr the hole to keep from

damaging the speaker wire. Treat the hole with a

paint or sealer to inhibit corrosion.

Step 3 – Connect the safety tether

Drill out safety tether hole using a

⁄4" drill bit on

enclosure depending on which side you would like

to mount the tether. Loop safety tether around Bar.

Next place tether bolt through tether ring and

rubber washer. Then put bolt through drilled hole

on enclosure and secure with metal washer and

locknut. Let enclosure hang by tether until next step.