TM652WB OWNERS MANUAL mtx.
Thank you for purchasing a MTX Marine product. MTX recommends that you have your wakeboard speakers professionally installed. Please visit MTX.com to locate the nearest authorized MTX dealer. TOOLS REQUIRED: • 10mm socket • 3⁄8" drill bit • 1⁄4" drill bit • Cordless drill • Speaker wire • 3mm Allen wrench • 5mm Allen wrench • Wire cutter NOTE: Speaker does not ship assembled, please be careful not to lose any parts.
WARNING STATEMENT: WARNING! Loud Music can cause permanent damage to your hearing. Please listen to your system at moderate volume levels. Mitek does not accept any liability for bodily harm, property damage, or any consequential damages resulting from the design, manufacture, sale or use of this product. PIPE DIAMETER INSERT GUIDE: Rubber inserts are numbered 1, 2, and 3. Insert #1 is the thickest and insert #3 is the thinnest. Pipe Diameter (in) *2.375 (23⁄8) 2.5 (21⁄2) 2.625 (25⁄8) 2.75 (23⁄4) *2.
INSTALLATION: Step 1 – First determine where you would like to place the speaker and at what angle the speaker will be mounted. Place enclosure on bar with desired angle and make a mark in the middle of the wire hole on the bar. This mark will be where the speaker wire will come thru the bar into the enclosure. Step 2 – Drill a 3⁄8" hole for the speaker wire on the mark that you made. Deburr the hole to keep from damaging the speaker wire. Treat the hole with a paint or sealer to inhibit corrosion.
Step 4 – Run speaker wire thru the bar and leave 8" – 12" of speaker wire hanging out of the hole. Next place rubber inserts into the enclosure and bracket. Please select the correct insert size according to the insert selection guide on page 3. Place round foam gaskets on to bracket standoffs. Place enclosure in desired location and pull wire through wire hole. Place top bracket on top of the bar above the enclosure. Start to thread the bracket screws into bracket from inside the enclosure.
OVERALL ASSEMBLY: 6
MTX WARRANTY STATEMENT: MTX products purchased in the USA from an authorized MTX dealer are guaranteed against defects in material and workmanship for the period of 1 year. The warranty period begins the day the product is purchased by the end user. This warranty is limited to the original retail purchaser of product. Product found to be defective during that period will be repaired or replaced by MTX at no charge.
© 2010 Mitek Corporation. All rights reserved. MTX and Thunder Marine are trademarks of Mitek Corporation. Designed and Engineered in the U.S.A. Due to continual product development, all specifications are subject to change without notice. MTX Audio, 1 Mitek Plaza, Winslow, IL 61089 U.S.A.
