Operating instructions

9. Use slotted screwdriver to check thrust ring
at both line ends for secure seating.
10. Tighten loose thrust ring to the specified tightening torque.
Name Size Type Lubricant Value/Standard
Thrust ring Tightening torque 5 Nm to 10 Nm
11. Coat screw head mating face (2) and
thread with engine oil.
12. Place hold-down clamp (1) in correct installation position. Tighten screw (2) with torque wrench to the
specified initial tightening torque.
Name Size Type Lubricant Value/Standard
Screw M12 Preload torque (Engine oil) 5 Nm to 10 Nm
13. Fit O-rings (4) and (6) on high-pressure fuel line (5) and coat with grease.
14. Tighten high-pressure fuel line (5) to the specified initial tightening torque.
Name Size Type Lubricant Value/Standard
HP line Preload torque (Engine oil) 5 Nm to 10 Nm
15. Tighten screw (2) to specified torque using a torque wrench.
Name Size Type Lubricant Value/Standard
Screw M12 Tightening torque 100 Nm + 10 Nm
M015412/03E 2012-02 | Task Description | 133
TIM-ID: 0000000952 - 006