Manual

DescriptionItem
Tighten to 20 lb•ft (28 N•m)2
Caution:
Install the insert so the side with three holes faces out. If this side faces in, the insert’s
O-ring may leak.
6. Install the O-ring on the force transducer’s insert. Then use a nylon mallet to tap the insert in place.
Install the Insert
DescriptionItem
Holes must face out.1
O-Ring2
Tap in place.3
7. Connect the force transducer’s cable to its feedthrough in the platen.
Unplug Lines
1. Remove the plug on the lower vent fitting. Install a vent hose on this fitting. Route the hose to a clean
5 gallon (20 litre) pail.
If you are going to use pore pressure in your test, unplug the two pore pressure ports.
Triaxial Cell Product Information | 79
Operation